- Screwdriver units vertical arranged in front of the stand
- Distance between the screwdriver units: 48 up to 110 mm synchronous adjustable from central point by hand wheel
- Workpiece height (screwing level) can vary up to 85 mm
- Constant screwdriving depth for all materials and independent of the workpiece height by the automatic depth of drive control
- Fitted with clamping device, continuously adjustable
- Front (right) screwdriver unit is disconnectable
- Input signals: start: electrical and manual, reset: electrical and manual; screwdriver selector: manual
- Automatic start of the hopper movement when operating
- Automatic shut down in case of pressure loss under 5 bar
- Screwdriving cycle time to insert two self-drilling screws (3,9×19 mm) for reinforcement fixing less than 3 seconds
- Feed capacity 30 to 80 screws per minute
Screw dimensions |
Motordata |
Head diameter: 6,0 – 9,0 mm | Max. speed: 2400 min -1 |
Shaft diameter: 3 – 4,5 mm | Max. power: 360 W |
Length: 13 – 45 mm | Min. torque: 5,9 Nm |
Special dimensions on request
Special versions:
- Rear screwdriving unit instead of the front one disconnectable
- Base plate of the screwdriver advancing units left side attached
Accessories:
- Mounting table h/l/w: 850 mm ( Mounting table with roller conveyors)
- Roller conveyor h/l/w: 850/1000/380 mm